Well services
Well Pump Repair in Northern Nevada
Symptoms, what a repair involves, and typical local costs — then get matched with a licensed local pump operator.
Common well pump symptoms
No water at all
Pump, power, pressure switch or control box failure.
Low water pressure
Pressure switch setting, clogged filter, failing pump or tank issue.
Short cycling
Pump clicks on and off rapidly — usually a waterlogged pressure tank.
Sputtering air
Low water level, a cracked drop pipe or a failing check valve.
Dirty or sandy water
Pump set too low, worn well screen or sediment disturbance.
Pump runs constantly
Leak in the system, failing pump or a bad pressure switch.
Lost water completely? Start with our No Water From Well guide.
What a repair involves
The operator starts by testing the electrical supply, pressure switch, pressure tank pre-charge and control box (for 3-wire pumps). Many "dead pump" calls turn out to be above-ground components.
If the problem is down the well, the pump and drop pipe are pulled — often with a pump hoist truck — to inspect the motor, wiring splice and check valve.
Typical well pump repair costs
| Service | Typical range |
|---|---|
| Well diagnosis / service callOften credited toward repair | $150 – $250 |
| Common repairs (pressure switch, wiring, check valve, control box) | $300 – $1,500 |
| Pressure tank replacement | $500 – $1,200 |
| Submersible pump replacementDepth and pump size drive cost | $1,500 – $4,000 |
Typical Northern Nevada ranges — final quote on site
Repair vs. replace
- Repair when the pump is under ~10 years old and the fault is a switch, control box, wiring or tank.
- Replace when the motor has failed, the pump is 10–15+ years old, or it has needed repeated pulls.
- Since pulling the pump is a major part of labor, replacing an old pump while it's already out often saves a second visit.
Well pump repair FAQ
How much does well pump repair cost in Reno?
A diagnostic visit typically runs $150–250. Common repairs like pressure switches, control boxes or wiring typically run $300–1,500. Final quote on site.
How long do well pumps last?
Submersible pumps commonly last 8–15 years depending on water quality, sediment, cycling and how hard they work.
Should I repair or replace my well pump?
If the pump is older than about 10 years, has failed before, or repair costs approach half of replacement, replacement is usually the better value.
Can I keep using water while the pump short cycles?
Limit use. Short cycling wears the motor quickly — often a waterlogged pressure tank or failed switch is the cause.
Need a well pump repaired?
Tell us what's going on. We'll connect you with a licensed, insured independent operator who covers your town. You get a transparent quote with no obligation.
(775) 555-0147